MYLAQ LED LAMP 18W/36W

MYLAQ LED LAMP 18W/36W

The device has 3 modes of operation:

•  30 seconds
•  60 seconds
•  99 seconds.

Low Heat Mode system:

That is gradual heating of the lamp. The power increases after 30 seconds and then after 60. This reduces the burning sensation during curing.

Motion sensor and display:

• The lamp has a built-in display that accurately shows the curing time.
•  In addition, this model has a motion sensor that causes the lamp to turn on automatically when you insert your hand. Then the maximum exposure time is 99 seconds.

Other benefits:

• The device has 21 LEDs that have been evenly distributed, which facilitates the hardening of the entire hand at the same time.
• Dual LED technology means that the lamp emits white light with a wavelength of 365 nm and 405 nm simultaneously. It is an energy-saving light source with high power and dual wave range.
• The lamp power is 18W, but it cures manicure like a 36W lamp.

Technical data:

• 21 LEDs,
• Maximum power: 18W / 36W,
• Voltage: DC 12V, 2A,
• Dimensions: 215 x 133 x 75mm,
•  Wavelength: 365-405nm, (Dual LED technology means that the lamp emits white light with a wavelength of 365 nm and 405 nm simultaneously. It is an energy-saving light source with high power and dual wave range. The lamp quickly and evenly cures the product).

Application:

1. Connect the lamp to the power supply.

2. After starting the device, select the lamp life using the 30s, 60s or 99s timer. Pressing the Low Heat Mode button will cause the device to heat up slowly. This mode is especially helpful in case of problems with paint hardening.

3. If you don't use the Timer buttons, the infrared sensor will start working when you insert your hand into the lamp. If the lamp is started with a motion sensor, the active working time counter will be displayed. The maximum working time without starting the Timer is 99s.

4. The device turns off when you reach out your hand.

5. After selecting the Timer mode, the display will show the time remaining to the end of the exposure.

European adaptor

Complaints policy
- the cost of returning the broken device is covered by the customer
- until the manufacturer makes a decision, the broken device is not refundable
- if the manufacturer cannot repair the device, the costs will be reimbursed
- it is not possible to exchange the goods for another one
- if the defect was caused by improper use, the repair costs are covered by the customer
- the warranty and its conditions are included in the warranty card